Prototype Measuring Report

When there is a request for measuring reports in the experiment order, the Scania form Measuring Report and Supplier Declaration must be used (the file below).

The form consists of two parts. Page 1, “Supplier Declaration” must always be completed by the supplier. Page 2, “Measuring Report” can be replaced by the supplier’s own measuring report as long as it is clear whether the requirements are fulfilled or not.

The supplier fills in the document and sends it  to Scania at proto.measuring.report@scania.com before delivery of the parts. The email subject should be Measuring report and part number (see picture below).

The attached file must contain ECO no., MR no., Order no., and Part no . according to the following example: ECO123456_MR123456_ON1234567_123456-1.pdf

No parts out of specification must ever be delivered unless the deviations are approved in writing by Scania.

Important:

Please be aware of how the file names shall be written. It should only be one part per report. There can be several parts per email, as long as all the part numbers are written in the subject.